Linksys router wrt 1900 ac7/14/2023 ![]() Keep the names of both the SSIDs different so that you can identify them.Ĭhange the password for the wireless network ( remember this password ). SSID is the name of the wireless network. Step 5: Change wireless settingsĬhange the Wireless network Settings as shown in the image below.Īs this is a Dual band router, you will see 2 different wireless networks. Once you change the Internet connections, you wired computer will be able to access the Internet through the WR1900ACS router. You need to enter the PPPoE user name and password as shown in the image below. You need to clone the MAC address of your computer, as shows in the image below. Please check the images below for appropriate Internet service provider settings. Now according to your internet service provider, you can change the Internet connection settings. Click on “Connectivity” under router settings section.Ĭlick On Internet settings tab at the top. In the left panel, you will see all the options required to change the settings. Step 4: Change Internet connection settings You will see the Linksys WRT1900ACS router setup page on your screen. If this is a brand new device then you can start with resetting it. ![]() Remember that you will lose all the settings of the router when you reset it. Release the reset button and wait for 30 seconds. Press and hold the reset button for 10 seconds. If the default password is not working then you can reset the device to the factory default. If you have changed it, enter the new password instead. However you can open the command prompt and check the IP address on your computer.Įnter your Router Password then click Log in. This is the default IP address of almost all the models. Open browser and in the address bar type the number 192.168.1.1 . You will see 4 lights, Power, WAN, wireless and Ethernet. If you have computer connected to the WAN port then it will not communicate with the Linksys router.Ĭonnection is very important. If you connect the modem and computer to the wrong port, you will not be able to open the Linksys router setup page. Connect the modem to the Internet port (which is standing alone ) and computer to the Ethernet port. Step 2: Make Connections to the routerĬonnect the computer and modem to the Linksys WRT1900ACS router with the Ethernet cable. if you do not have PPPoE user name and password then get in touch with your Internet service provider and get it. Make sure that you have the correct PPPoE user name and password. In this case you must have PPPoE User name and password from the DSL company. In case of DSL connection, you may not be able to access the Internet directly through the modem. If you are not able to access internet directly through the modem then contact your service provider and get your modem working first.
0 Comments
Leave a Reply. |